Profit Analysis for Single Unit Computerized Numerical Control Machine (CNC Machine) Having Different Types of Faults with Single Repairman Facility

Reetu Bala; Naveen Kumar

doi:10.36676/irt.v10.i3.1567

Authors

Reetu Bala Research Scholar, Department of Mathematics, Baba Mastnath University, Asthal Bohar, Rohtak-124021(Haryana)
Naveen Kumar Professor, Department of Mathematics, Baba Mastnath University, Asthal Bohar, Rohtak-124021(Haryana)

DOI:

https://doi.org/10.36676/irt.v10.i3.1567

Keywords:

CNC Machine, MTSF, , Semi Markov Process, Regenerative Point Technique

Abstract

The Reliability analysis of a single unit CNC machine run by mechanical and electrical engineers (repairmen) under certain inspection protocols is the focus of this research work. The facility has just one repairman. Both total and partial system breakdowns occur. The repairman first examines the system, classifies the issue as either repairable or non-repairable, and then performs the necessary replacement or repair. Different types of machine faults are categorized as major, minor, and deterioration. The Semi Mark0v process and the Regenerative P0int approach were used to analyze the system. Every computation was performed using actual data that was gathered from Shivam Auto-tech Limited, IMT Rohtak.

References

Branson, M.H. and Shah, B. (1971), “Reliability Analysis of System Comprises of Units with Arbitrary Repair Time Distributions”. IEEE Transactions on Reliability, Vol. 20 pp. 217 – 223.

Arora, J.R. (1977), “Reliability of Several Standby Priority Redundant Systems”, IEEE Trans Reliability, 26(1977), 290-293.

Yamashiro, M. (1980), “A Repairable Multiple State Device with General Repair Time”, IEEE Transactions on Reliability, R-29, (3), 276.

Murari, K. and Goyal, V. (1983), “Reliability System with Two Types of Repair facilities”, Microelectron. Reliability, 23, 1015-1025.

Malik, S.C. (1992), “Cost-Benefit Analysis of Reliability Models with Different Types of Repair and Inspection Policies”, Ph.D. Thesis, M.D. University, Rohtak.

Taneja, G. and Tyagi, V.K. (2004), “Profit Analysis of Single Unit Programmable Logic Controller”, Pure and Applied Mathematical Sciences, 60(1-2), 55-71.

Malik, S.C. and Barak, M.S. (2009), “Reliability and Economic Analysis of a System Operating Under Weather Conditions”, Journal of Proc. National Academy of Sci., India, Sec. A, 79(II), 205-213.

Malik, S.C. and Gitanjali (2012), “Analysis of a Parallel System with Maximum Repair time and Single Server who Appears and Disappears Randomly”, International Journal of Mathematical Archive. 3(2012), 4700-4.

Taneja, G. and Malhotra, R. (2013), “Cost-Benefit Analysis of a Single Unit System with Scheduled Maintenance and Variation in Demand”, Journal of Mathematics and Statistics, 9(3), 155-160.

Singh, N., Singh, D. and Saini, A.K. (2017), “Cost Benefit Analysis of Two Non-Identical Units Cold Standby System Subject to Heavy Rain with Partially Operative after Repair”, Global Journal of Pure and Applied Mathematics, 13(2017), 79-100.